Installing the Sensor on the Trawl

The Trident Pro sensor must be installed on the headrope or footrope of the trawl using appropriate equipment.

About this task

Two installations are possible:
  • Installation on the headrope: Trident Pro is configured in Down Looking mode.
  • Installation on the footrope: Trident Pro is configured in Up Looking mode.
Notice:
Remove the Trident Pro sensor from the trawl before winding the winch or you will damage the housing.
Note:
When fishing close to the surface, preferably install the sensor on the footrope in Up Looking mode. The acoustic communication with the vessel and echogram images will be better.

Procedure

  1. Place the sensor on the center of the net's headrope if it is in Down Looking mode or footrope if in Up Looking mode. The side with arrows must be oriented toward the vessel. Make sure the beams are oriented correctly, depending on the sensor application:
    • Down Looking: the face with one hole is facing up.

    • Up Looking: the face with three holes and one screw at the bottom is facing up.

  2. Attach the sensor to the net using four soft shackles.
    Note:
    See Technical Specifications for shackles specifications.
  3. You can add floats on either sides of the sensor to stabilize it and have pitch and roll values between +/- 5°.