Configuring the Sensor Settings

You need to complete communication settings when you add the sensor to the receiver.

Important: Make sure the settings you enter here are the same as in Mosa2.

1 Sensor name displayed in Scala2 and its features.
2 Enter the same frequency as the one entered for the uplink frequency in Mosa2.
3 Click Configure to change filters applied on incoming data. Filters are particularly useful to reduce interferences on the echogram data.
Note: Be aware that echogram filters such as Echosounder and Interference Reduction may remove small targets on the echogram.
Tip: Please refer to Scala2 user guide for more information about the filters.
4-5-6 Select the same sounding direction, range, and detection threshold as those set in Mosa2.

Click Apply when you have finished.